Navigation
pxc001: unable to load configuration information, Px KNX Tool may not be able to import data properly
Created by: Bob_L at: 12/31/2024 10:22 AM (1 Replies)
Rating 
Thanks 0
2 Entries
| 12/31/2024 10:22 AM | |
Joined: 9/12/2023 Last visit: 2/3/2025 Posts: 2 Rating:
|
Hello, colleagues. I'm in a similar situation. PLC- pxc-001e.d. If you go through the PX KNX Tool, an error appears: "unable to load configuration information, Px KNX Tool may not be able to import data properly.". If I go the route of entering group addresses directly, then I display the block Fnc02Busf in Xworks. I get the data from the thermostats correctly, I can manage the modes... 1 Question: Can I get the data from all the parameters of the thermostats in this way, and I am interested, is it possible to set some block for parameters 86 and 87 - mode blocking and setting input blocking ??? 2 Question: Correct integration of the project through PX KNX Tool from ETS v6 is possible or is ETS v5 and below required??? ------------------------------------------------------------------------------------------ |
Last edited by: Moderator_Lan at: 12/31/2024 10:48:54New subject after splitting |
|
Follow us on