Hello everyone,

I'm working on a project with LOGO! Siemens and need some help with a piece of program code for controlling a pump.

The idea is as follows:

• Start the pump.
• If the flow rate doesn't exceed a certain value after 10 seconds (if the value is too low), an error message should occur (for example, by turning on a light).

Would anyone on this forum be willing to program this for me?

Thanks in advance!

Why open you a new topic?

You ask for the same in this topic:

ho can pre-program a Siemens LOGO! for me? (Pump monitoring + alarm light)

Topic closed because the question has been posted twice. The active topic can be found via the link posted above.

Kind regards, Moderator_Lan