Hello,

How do I configure the I/O that is send through a CP342-5 module to the S7400?

What I did right now iswriting the necessary I/O from the S7300-cp342-5 to the master with SFC14/15, where it stores the I/O in a datablock.
"Note that I cannot test anything yet because of the missing S7400".
From there the data is send to memory bits/words and used in CFC.
Iinterconnect the memory bits/words in the S7400 program directly to the CFC blocks.

Must Iusea driver block for these I/O? because driver blocks (CH_AI etc..) are used for ET200 only..
Also, just like my question for connecting the drives, I can use PIP area in the CPU to directly access my data?

Thxx