SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

How to move the axis prior to referencing.

2/22/2011 11:28 AM	Rate (0)
PISCEAN 2010 Posts: 8092 Rating: (884)	Hi Experts, We have equipped with 802D controller. I would like to know how X or Z axis can be moved after power ON prior to referencing of axis? Can any one help me. Thanks in advance. DEEP.
PISCEAN 2010 Posts: 8092 Rating: (884)
Suggestion To thank Quote Answer

2/22/2011 12:05 PM	Rate (0)
Caldas Bronze Member Joined: 9/10/2007 Last visit: 1/12/2026 Posts: 71 Rating: (1)	Please lookthe MD34110 REFP_CYCLE_NR. Good luck.

Suggestion To thank Quote Answer

2/22/2011 12:52 PM	Rate (0)
PISCEAN 2010 Posts: 8092 Rating: (884)	Hi caldas, Thanks for your reply. You have mentioned the MD which is to configure the sequence of referncing the axis. My question is, after power ON, at first without referencing the X or Z axis, I want to move it in JOG mode, then how it should be achieved? e.g. my X or Z axis referencing cam is towards -ve side & my actual slide position is away from referencing CAM. In this position, after power ON, manualy in JOG mode operator needs to move axis opposite to refernce CAM & then selcting REF mode &presses -Z, then only referencing is possible. So to achieve this, axis must be operational in JOG mode prior to reference. Hope this is clears you about my problem. DEEP.
PISCEAN 2010 Posts: 8092 Rating: (884)
Suggestion To thank Quote Answer

2/23/2011 10:42 AM	Rate (0)
OvidiuNastac Posts: 419 Rating: (19)	Hi I think that the machine manufacturer had blocked the movement of the axis toward the opposite direction of the referencing direction in the PLC or the movement is only possible with the handwheel. So you must check V380x0004.6 or 4.7 and V10000004.6 to V10000005.5 Good luck Nit
OvidiuNastac Posts: 419 Rating: (19)
Suggestion To thank Quote Answer

2/23/2011 12:17 PM	Rate (0)
RAM81 Silver Member Joined: 3/3/2008 Last visit: 4/9/2025 Posts: 333 Rating: (52)	hi deep normally you will be able to move the axis in jog mode prior to reference, if you are at the limit then you can move it in the opposite direction , this operation is on case to case basis..depends on the interlock's of the machine. regards ram

Suggestion To thank Quote Answer

2/24/2011 7:23 AM	Rate (0)
PISCEAN 2010 Posts: 8092 Rating: (884)	Hi Nit & RAM, Thanks for your reply. I will check the same & revert back. DEEP.
PISCEAN 2010 Posts: 8092 Rating: (884)
Suggestion To thank Quote Answer

Share this page:

Share this page on...