Navigation
Rating 
Thanks 3
4 Entries
| 10/18/2011 5:24 PM | |
|
Posts: 28 Rating:
|
Hello, I think the G code which you list is the command in ISO mode, just like CYCLE72,CYCLE82,and so on. So you need use G291 at the beginningof the program |
| 10/19/2011 2:18 PM | |
|
Posts: 3 Rating:
|
Hello, G92,72, 80, 81 & 82 function only works in ISO dialect mode i.e., G291 mode. Refer the document which is attached here with. Ensure that before modification above machine data take the machine backup which will reorganize the buffer memory. Syed Imtiyaz AttachmentISO_cycle.doc.pdf (448 Downloads) |
Last edited by: syed_si at: 10/19/2011 2:18 PM |
|
This contribution was helpful to
|
|
| 2/1/2012 12:56 AM | |
|
Posts: 71 Rating:
|
Thank You Syed for your information. my problem is when i Use G291 Ihave anNC fault 12470. please advice How to activate G291. Thanks Tarik |
Follow us on