SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

RESET SINUMERIK 880

3/18/2012 10:31 PM	Rate (0)
SI-HACENE Posts: 39 Rating: (0)	HELLO is there any one who has the reset procedure or a link of sinumeriK 880 with a CPU 135WD with EEPROM. error message in screen FAULT CPU NC 43. thank you in advance
SI-HACENE Posts: 39 Rating: (0)
Suggestion To thank Quote Answer

3/19/2012 6:36 PM	Rate (0)
MBA Posts: 594 Rating: (79)	http://support.automation.siemens.com/WW/view/en/32027210/133300
MBA Posts: 594 Rating: (79)
Suggestion To thank Quote Answer

3/19/2012 7:23 PM	Rate (0)
SI-HACENE Posts: 39 Rating: (0)	HI , thanks for your replay , in the link I find just a description and a manuel for use , but I want the way for upload the program NCfrom CPU135 after a gerneral reset caused by the battery low , I have the program in the EEROMS and a consol or a siemens S5 cable with S5 to do this . but how !!!! waitting for a response thanks .
SI-HACENE Posts: 39 Rating: (0)
Suggestion To thank Quote Answer

3/19/2012 8:17 PM	Rate (0)
MBA Posts: 594 Rating: (79)	you want to load the S5 Program from EEprom to Ram ? Manual http://support.automation.siemens.com/WW/view/en/22089081 chapter 11
MBA Posts: 594 Rating: (79)
Suggestion To thank Quote Answer

3/20/2012 3:33 PM	Rate (0)
SI-HACENE Posts: 39 Rating: (0)	Hello thank you for the information, I tried this morning to the general procedure to erase and reload from EEPROM the program but I have just only this of the green LED on the CPU135 wb 6fx1138-6bb01lights but on the other card is red 6fx1120 4bb03-red LED 6fx1138 4ba01-red LED 6fx1132 0BA01-red LED then when and where I must use the password 162 ?? is there a procedure to upload the program into the nc ?? to have all leds green thanks
SI-HACENE Posts: 39 Rating: (0)
Suggestion To thank Quote Answer

Share this page:

Share this page on...