I have to program SIMOREG1P6RA7085-6DS22-0 for following motor

Armature =440vDc631Amp.

Field=180vDc23.5Amp.
500~1200R/Min..

the motor is placed on rolloing mill, we required high toruque to for production, motor run on its base speed. Normally we run motor idle upto 350VD.C then inject product for drawing, suddenly for 10-30sec. drive current shoots upto its maximun then got normal.

I have to program according to following connection .

speed feed back by TACO at 103/104

POT connection terminal 1/2/4/5

terminal 34/37/38 are using for enable and ON

terminal 39 for Jog speed

terminal 46/47

terminal 109/110

terminal 14/15 for actual armature volt

terminal 12/13 for actual armature current

please guide me what steps i should follow to program that drive, further more i dont see any parameter for current.

Thanks