SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Sinamic Fault

6/20/2013 8:17 AM	Rate (0)
855 Posts: 6 Rating: (0)	Dear Tech Team, I have a problem with PM 240 G120B when I'm running the inverter the error code F07900 are display on screen. Why these problems occur and can anyone give me a solution for this problem.
855 Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

6/20/2013 4:02 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 1/8/2026 Posts: 6065 Rating: (828)	Hello, this message means that the motor is blocked. I assume that the load is to much. Check p0640, p1538, p1539. Decrease the load. Contact the customer support with your STARTER project.
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

7/3/2013 3:53 AM	Rate (0)
855 Posts: 6 Rating: (0)	Dear expert, Thanks for the answer.
855 Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

7/3/2013 6:55 AM	Rate (0)
sparten Posts: 205 Rating: (11)	Hello 855, for which application are you using this Drive??? what is controll mode??? are you using drive in close loop means any encoder are you using??if yes then check encoder feedback.. if possible then try to run in no load condition ..is it rotating freely in this mode????
sparten Posts: 205 Rating: (11)
Suggestion To thank Quote Answer

Share this page:

Share this page on...