SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

G120C PN v4.6 - PU enable missing

2/26/2014 6:44 PM	Rate (0)
LievenDHaese Advanced Member Joined: 5/19/2011 Last visit: 1/14/2025 Posts: 24 Rating: (1)	When I try to start a motor, I get an error r46.21 PU enable missing. At this moment the motor won't run. But now and then, the message disappears and the motor starts until the message returns. What is the message and what to do to prevent it from popping up?

Suggestion To thank Quote Answer

2/28/2014 9:29 PM	Rate (0)
zako_ Posts: 895 Rating: (67)	Is it possible to move the axis with the control panel?
zako_ Posts: 895 Rating: (67)
Suggestion To thank Quote Answer

3/3/2014 1:10 AM	Rate (0)
casey Advanced Member Joined: 1/6/2011 Last visit: 11/4/2025 Posts: 45 Rating: (0)	try replacing CU

Suggestion To thank Quote Answer

3/3/2014 10:49 AM	Rate (0)
LievenDHaese Advanced Member Joined: 5/19/2011 Last visit: 1/14/2025 Posts: 24 Rating: (1)	I'm sorry for your time guys. I found the problem. In the PLC-program I use a function to write the data to the drives. There I saw the address to send the data to was not changed (Step7 crashed so all changes lost...) So I was sending 2 different commands to 1 drive. And this one didn't understand what happened. I changed the addresses and everything works perfect again

Suggestion To thank Quote Answer

Share this page:

Share this page on...