SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

ET200S wiring

3/13/2014 12:36 PM	Rate (0)
allayahassine Posts: 133 Rating: (0)	Hi everybody, For a given length L of a shielded cable connecting an ET200S Analog Module to a sensor, is there any solution to increase the resistance value of this cable to a certain value ? thanks!!
allayahassine Posts: 133 Rating: (0)	Last edited by: allayahassine at: 3/13/2014 12:42 PM
Suggestion To thank Quote Answer

3/15/2014 10:35 AM	Rate (0)
IBN-Service Posts: 8946 Rating: (1000)	Do you mean, your resistance is to high because cable is to long? Then try bigger diameter.
IBN-Service Posts: 8946 Rating: (1000)
Suggestion To thank Quote Answer

3/15/2014 10:50 AM	Rate (0)
allayahassine Posts: 133 Rating: (0)	No it is the opposite: my resistance is small and i want to increase it without increasing the length of the cable, if it is possible of course
allayahassine Posts: 133 Rating: (0)
Suggestion To thank Quote Answer

3/15/2014 12:02 PM	Rate (0)
IBN-Service Posts: 8946 Rating: (1000)	Normaly, there is absolute no reason to increase the CABLE resistance! Why do you think you have to increase resistance / impedance of cable? What sensor? Do you havea datasheet? Watch it, that analoge input gets already a resistance by itself! High (some kOhm), if voltage input. Low (some Ohm)if current input.
IBN-Service Posts: 8946 Rating: (1000)	Last edited by: IBN-Service at: 3/15/2014 12:06 PM Oh dear, I just do a look onto your other questions... Perhaps you first need some BASIC Training about electric rules and equipment before you try to setup PLC.
Suggestion To thank Quote Answer

Share this page:

Share this page on...