SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Quick commissioning DCM 6RA80

1/6/2015 11:03 AM	Rate (0)
lsierdsma Posts: 24 Rating: (0)	Hi, I connect my DCM to starter, choose Configure Drive Unit and set these most important parameters. After this configuration, i want to start the drive with the control panel, but i'am missing the first enable OFF1, so when i starts, the drive goes into fault. Any suggestions for simple configuration to get the motor running? I also tried to connect the AOP30 on the DCM om connector X178 and set p2030 to 3 AOP30 can not connected with DCM. AOP30 tell: Waiting for com...
lsierdsma Posts: 24 Rating: (0)
Suggestion To thank Quote Answer

1/7/2015 11:34 AM	Rate (0)
KSN Diamond Member Joined: 8/25/2006 Last visit: 1/15/2026 Posts: 2221 Rating: (282)	lsierdsma I connect my DCM to starter, choose Configure Drive Unit and set these most important parameters. After this configuration, i want to start the drive with the control panel, but i'am missing the first enable OFF1, so when i starts, the drive goes into fault. Hello. Did you make all required optimization runs? Apart from ON command in control word you must also give ON command from terminal X177:12 (this is your OFF1 enable missing I think). Look atList manual, function diagram 2050.

Suggestion To thank Quote Answer