SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

802C Baseline reference point apporch problem

8/16/2012 4:35 PM	Rate (0)
ayalabik Posts: 1 Rating: (0)	Hello, We are experiencing the same problem with a 802d base line mill. The machine data MD11300 is not present, and we have checked all the related settings. I would appreciate if you could post how you solved the problem... Thanks in advance..
ayalabik Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

8/19/2012 7:20 AM	Rate (0)
DigitalMG Advanced Member Joined: 4/18/2010 Last visit: 1/28/2024 Posts: 65 Rating: (0)	Hi, There will be no need to MD11300. You may add some line in PLC program to the following job. 1- Check if HMI is in Reference mode ( Not JOG or AUTO or MDA) 2- Check in PLC for X/Y/Z/.. axis + direction traverse key to be pressed by the operator. 3- Keep + Traversing Motion control signal activated until the desired axis recived Reference signal from motion control even + Traverse key is not keeping press. it should be de-activated by pressing reset key or exit from Reference mode. This will send each pressed + traverse axis to Ref CAM automatically and stops when referencing is completed. Thanks

Suggestion To thank Quote Answer

5/19/2015 3:52 PM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by DRotunno is split to a separate thread with the subject I802-M-T-FX06-XX upgrade firmware. Best regards Min_Moderator

Suggestion To thank Quote Answer

7/1/2015 2:09 PM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by mostafa1984 is split to a separate thread with the subject 802C, problem in reference mode. Best regards Min_Moderator

Suggestion To thank Quote Answer

Share this page:

Share this page on...