Hi all,

I just insert a new Simocode in a ligne Prifibus with 9 others simocode in the same serie .

The first essay i adapte the HW config and dowload it in PLC okk

For test i just take the profibus for a simocode in the same serie and put it in the new simocode The liason is okk no Problème.

Now we linked a new cable of profibus from the simocode who are closed To the new one result 3 of simocode had lost connection 

in first case the conection was add profib 3,4 -->ok  ,3--19 -->ok,  3,4,19 --> Nok

plz if the is same condition that i nees to respect for make this connection or i nees to make another dowload for HW config or ....? i need your help

Hello,

check the new PROFIBUS Cable and Connectors, and the termination on the connectors.

Regards

Christoph

closed cause the question is published twice.

The second thread with the subject add a new equipement interrupt the profibus conection is published within the conference Communication / Networks.

Best regards
CS Moderator

Problème Resolved

the Profibus cable connected to 3 Simocode was poorly wired