Marek cz

Hello all

my problem is in timer on my program. When I set timer on pc in Softcomfort V8.1 all program OK.

I have this timer Tx on my logo tde display try change value, value write on display but logo not change. I try change this Tx in menu from logo setting  set program parameter Tx change on display see change but in plc not change value. All time is only value from softcontrol. Its timer ON dealy.

All program is ok but only need change value from timer Tx.

Thanks for help :)

note:

I try change to admin or OP mode - same problem

my ip plc 192.168.0.3, display 192.168.0.2 - comunication ok, alll value or funkction is ok.

Try do other timer on delay - change on display - same problem.

A few days ago a user already complained about this misconduct.

Change delay time on TDE doesn't change on the Logo

I would create a support request in your place.

Marek cz

If I understand must set ip in dispay higher from plc ip?   

No I did not mean that.

Through the link I wanted to point to the topic. There the user has the same problem. I do not know a solution for this. So I suggested that you start a Support Request.

The error description reads like a bug in the LOGO! or in the Software.