Hello Experts ,

Actually I need  an Alarm that shows Report  system erros ,so i sheck S7 alarm on wincc , when I start my simulation ,i take off the the input modul from the rak First , ,but nothing appear on Runtime,the only messag that I get is : established liaison, I also make stop to my cpu but no alarm apear about the state of all module , Can you tell me what I need to add to get All default system .Thanks you

Regards ,

Hi,

Please check chapter 6 of this manual for how to configure alarms, reports, logging..

For specific alarms you can program them on PLC side and you can make it a discrete alarm in wincc flexible.