Hi Experts!

I'm currently doing a project with a WP522 on a S7-1515F2 in TIA V14 SP1 Upd 5.

I was wondering if it is possible to do some configuration (e.g. calibration etc.) via the webbrowser with the WP522? The manual says some config is possible this way, but I cannot find any further information. 

In the process a container is filled with product for which the actual weight is needed, so when a certain weight is reached (max 5000Kg) filling is stopped.

So in short:

• Is this possible via the webbrowser of the WP522?
• Do I need the siwatool application (If siwatool is preferred, would V7 be compatible for the WP522?)
• Would a simple program with commands do the job?

Hope to hear from you soon

Hello Domino.

the Webserver for the Siwarex WP522 is unfortunately not released yet.

The possibility's to configure are the following:

1. Siwatool V7, with Siwatool V7 you can connect via Ethernet to the Ethernet port of the Siwarex WP522 and configure all parameters, see manual chapter 5.6. https://support.industry.siemens.com/cs/ww/en/view/109742780 Siwatool is running without TIA-Portal and easy to use.
2. Via HMI, the example project includes a panel project that allows full access to the parameters of the Siwarex WP522, see https://support.industry.siemens.com/cs/ww/en/view/109736579 . See also manual chapter 5.5
3. With S7 program, in the Instance-DB of the Siwarex WP522 FB you find the data of the Siwarex WP522. With these you can do your settings write the data to the Siwarex WP522 and send commands. The panel project of 2. is doing the same.

Regards

ABenno