I have a 4 - 20 ma pressure sensor which ranges from 0 - 0.6 bar pressure, connected to Analogue input module AM2.

So in FBD, I have analog input connected to analog threshold at default settings of 0 -1000, then I set 1 decimal point for messages. All works fine

4ma = (0 bar) = 0%

20 ma (0.6 bar) = 100%

Using the above sensor, I want the message to show 100% at 0.35 bar instead of 0.6 bar.

How do I do this ?

Thanks a lot for your help m8, much appreciated. Worked a treat. The proverbial "easy, when you know how"

Thanks again.