Hello ixo 65,

thanks a lot for the prg, that was exactly what i was looking for,

thanks again mate!

regards,

Time ago I did handicap platform lift wit landing doors and safety elements on the shaft.

Perhaps you can use some part of the program.

Note:

OBA8 standard

INPUTS

I1 PUSHBUTTON FLOOR 0
I2 PUSHBUTTON FLOOR 1
I3 TOP FLOOR SWITCH
I4 BOTTON FLOOR SWITCH
I5 SAFETY IMPUT (N.C.)
I6 LIMIT SWITCH (N.C.)
I7 LANDING CONTACTS (N.C.)
I8 LANDING LOCKS (N.C.)
C4► Screen change
F1 UP Inspection
F2 Down Inspection
F3 Inspection
F4 Screen change

OUTPUTS

Q1 MOTOR UP
Q2 MOTOR DOWN
Q3 RUN / DOOR OPENED (Light on= Running, Light flashing= doors opened)
Q4 CAR LIGHT

INSPETION MODE: Keep pressed F3 more than 3 seconds an press F1 to move UP or F2 to move down.
Car light will switch off 30 seconds after lift stops or landing door closing.