Dear all Expert. 

I try to Transfer Project from WinCC Flexible to MP277 Touch Panel on EtherNet protocol. I've already set right type of connection and transfer as Ethernet on device ok, but when i transfer, PC could not establish connection with device. Message show as picture below.

While I use ProSave to Back Up or Transfer on the same computer via EtherNet it work well. I dont know why. Anybody can help me?

Thank in advance.

Hello Lucas,

same IP range for your notebook and in the transfer settings of the panel?

On the panel transfer via Ethernet is selected?

Panel is in Transfer mode?

Regards,

Frink