Dear Experts,

I use TIA Portal V15 I use PLC S7-1515-2 PN and I would like to control 4 AC motor which use SINAMICS S120 CU320-2 PN.

I will use SINAMICS STARTER software in order to config drive. 

How can I configuration PLC and SINAMICS S120 in TIA Portal ?

How can I configuration SINAMICS S120 in STARTER ?

How can I setting telegram for control drive both in STARTER and TIA Portal ?

Best Regards,

Vorapob

Hi,

I would recommend to install Startdrive (free of charge) to your TIA Portal environment. Then you don't need to setup the S120 in Starter. You can do everything (PLC and drive) in TIA Portal.

This makes the communication config easier than using the GSDML file (as shown in your attached picture).

If you want to stick to use STARTER I recommend to do the following:

1) setup the drive unit in Starter

2) generate the GSDML file in Starter for your drive (at the end of drive config!)

3) install the GSDML file to TIA Portal and connect it to the PLC.

4) Make sure that IP address and PROFINET name of the GSDML file are correct (same as the device online actually has).

The GSDML file can be generated in Starter by using a script. You can find it here:

https://support.industry.siemens.com/cs/ww/en/view/92022677

Dear RB91,

Thank you very much for your recommendation.

Best Regards,

Vorapob