Sir,

what is the part number of that sir.

its working in another laptop but i dont know why its not working in my laptop .

both laptop same configuration and same model.

Hi,

You will need to check that you have the correct IP address settings for your NIC.

Are you using a static address? Or DHCP?

Regards,

AutoGen_3177036

Hi every one,

I have one PXC100 E.D controller ,I did the node configuration and after compile i didn't found any error.while downloading the program to the controller one error message is showing .

error msg: Error 7194: The automation station could not be connected online!

if any one can help me from this issue it would be appreciable.

screen shot also attached.

 I have got the same error, If I am not wrong you will get the same error while downloading the program into CFC Simulator. 

I have tried too many things but end up with the same result, so I have Uninstall-Install the XWP again and problem solved.

still, the cause is unknown.

Hi,

I am getting the same ''Error-7194: The Automation station could not be connected online'' again, and this time with PXC100.D.

I am getting this error even when I am downloading the programme to Simulator. anyone have an idea?

regards

Hi all, 

I am having the same error message with a new PXC100-ED. I can do a node setup, check online properties, ping the controller, absolutely no issues until I trying to download, it connects, then gives Error 7194. 

any ideas?! Thank you!

Hi

Did you check PG/PC interface Settings?