ixo65

You only want to know if is it possible to active the trigger of the pulse relays with another function instead of the cursorkey C4?

You can use a softkey.

This can be parameterized as a switch or button. Retentivity can also be activated.

The softkey is operated via the LOGO! display. To do this, it must be called up in a message text.

To operate:

Select the corresponding message text with I1 or I2. Then press the ESC key until a black bar appears on the softkey in the message text. Then press the OK button. The black bar is now flashing. Use the cursor up (or down) to select the change in status, the text changes from OFF to ON. Press the OK key again, the softkey emits a pulse and the status display shows OFF again. Press the ESC key again to exit the mode.

See attachment ...

 Yes!

I do some little modification:

• I use a separate softkey for each selector
• The softkey is configured as switch with retention active
• The softkey is used to set rele block (that at this point is not necessary to be retentive)

What do you think?

Do you agree?