I need to test some settings in my PG with TIA v18.

In order to do this I want to download a small project to a basic panel.

When / if I succeed with this I want to "factory reset" the basic panel and put it back in our spare parts warehouse.

CAN I "factory reset" the basic panel and if so the HOW?

Hello

Yes, you can perform a factory reset to a basic panel. You can do it through Prosave. I attach a link to the calendar that will surely be of help to you. 

- https://support.industry.siemens.com/cs/ww/en/view/90114350/56848595467

Hello,

In addition, have a look at the following link:

USB Recovery (Reset to factory) Mode for 2nd Generation Basic Panels

Best regards,

Wizard

Hello Hank88,

Thank you for answering.

I don't have ProSave - is that a program I can download for free?

Hank88

Hello

Yes, you can perform a factory reset to a basic panel. You can do it through Prosave. I attach a link to the calendar that will surely be of help to you. 

- https://support.industry.siemens.com/cs/ww/en/view/90114350/56848595467

Hello Wizard,

Thank you for answering.

That is a good option - i might very well use that too.

However - I don't see an image for basic panels for TIA v 18?

Image Downloads for SIMATIC HMI Operator Panels: Comfort / Mobile / Basic Panels - ID: 109825750 - Industry Support Siemens

Wizard

Hello,

In addition, have a look at the following link:

USB Recovery (Reset to factory) Mode for 2nd Generation Basic Panels

Best regards,

Wizard

Hello again xmnj!

Yes, it is a software that you can use for free. You can apply it directly from this entry, or through the TIA Portal installer itself. 

- https://support.industry.siemens.com/cs/ww/en/view/10347815

I hope it will be helpful 🍀

Hello xmnj,

The latest image version is v17 upd 8

That is the image version, that is used with TIA Portal v17, v18, v19 and v20.

You can download it from the link you mentioned.

Best regards,

Wizard