Hi,Dear

Actually 1 question:

Do in starter or simotion scout software for sinamics drive,when we limit the current or torque by parameter p640 and p1520,p1521 and ...It means the motor can not go to upper of this current and torque not at all and if we pass over of this limit the drive will give the fault  and stop?or No it means the drive limit it's self max. to this parameter and don't allow the load force it to more torque and power support without any fault?

best regard

electrical engineer

bagheri

HI,Dear

Actually I want to know when we put the current limit for example in p640=1000 A ,after motor current goes up  to 1001 A drive will give the fault and stop the motor or No, it will limit motor current to 1000 A and continuous working without every fault or goes to more current.(also for torque limit in p1520)?

best regards

bagheri