SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Transverse Axis in Target Position window

1/15/2020 3:46 PM	Rate (0)
Meuil Advanced Member Joined: 4/28/2015 Last visit: 7/15/2024 Posts: 9 Rating: (0)	Hello all. I'm commissioning a vertical lathe with 840D sl. Using NCU HMI (NC software version is V04.08/SP02/HF03) X axis is configured as transverse axis, but programming and displaying are in radius mode (MD10136=1, MD20100=X MD20360=0h) Axis work properly in JOG and AUTO mode. The issue appers only in the Target Position window, I have to put target in diameter, i. e. X6000, then press cycle start and the axis is moving to 3000mm. Is there a parameter to change this ? Regards. Meuil

Suggestion To thank Quote Answer

1/24/2020 10:00 AM	Rate (0)
Meuil Advanced Member Joined: 4/28/2015 Last visit: 7/15/2024 Posts: 9 Rating: (0)	Solved. Just leave MD20100 blank

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Jen_Moderator

Share this page:

Share this page on...