Skip to Content

support.automation.siemens.com | Technical Forum | Thursday, September 4, 2025 4:58:26 AM

Print

configuring Sinamics CU310-2 and PM240-2 in TIA V18

Created by: Dummie at: 10/5/2023 8:01 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

10/5/2023 8:01 PM	Rate (0)
Dummie Advanced Member Joined: 4/29/2010 Last visit: 8/14/2025 Posts: 26 Rating: (0)	Hi Forum, I have TIA V18 installed. Request is for a CU310-2 (6SL3040-1LA01-0AA0) and a PM G120 PM240-2 (6SL3210-1PE31-5AL0). I am trying to configure them in TIA, but i can't find the way to configure them both.. I must be doing something wrong. I can add the CU, but no way to insert the PM.. How knows this trick? thanks!

Suggestion To thank Quote Answer

10/5/2023 8:26 PM	Rate (0)
in zr57 Joined: 3/28/2023 Last visit: 7/31/2025 Posts: 27 Rating: (4)	Not sure if I'm understanding correctly, do you mean the hardware configuration? If so, could you try drag and drop the PM by the CU like in the attached? Please correct me if you mean something else. Attachment Untitled1.png (351 Downloads)
	Last edited by: Fernando_VC at: 10/05/2023 20:27:18 Last edited by: Fernando_VC at: 10/05/2023 20:27:55
Suggestion To thank Quote Answer

10/6/2023 5:37 AM	Rate (0)
Dummie Advanced Member Joined: 4/29/2010 Last visit: 8/14/2025 Posts: 26 Rating: (0)	Hi, yes that is exactly what i mean.. in my TIA it won't work.. thxs,

Suggestion To thank Quote Answer

10/6/2023 5:38 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 9/2/2025 Posts: 22709 Rating: (3071)	any screen available what exactly you try to do?

Suggestion To thank Quote Answer

10/6/2023 6:03 AM	Rate (0)
Dummie Advanced Member Joined: 4/29/2010 Last visit: 8/14/2025 Posts: 26 Rating: (0)	ok, found it finally, it was below in my screen... topic solved. Thanks for bringing me in the correct direction!

Suggestion To thank Quote Answer