Skip to Content

support.automation.siemens.com | Technical Forum | Sunday, September 14, 2025 8:32:55 PM

Print

pc connection kit

Created by: jolter ggg at: 5/5/2013 10:12 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

5/5/2013 10:12 PM	Rate (0)
jolter ggg Posts: 49 Rating: (0)	i am setting parameters of mm440 by using drive monitor . my drive monitor (software in pc ) is connected to the drive mm440 through zero cable. when i am clicking on online button in drive monitor software there is an warnning error occurs . i am adding here another issue : my pc connection kit have two led green and orange both of them are blinking
jolter ggg Posts: 49 Rating: (0)
Suggestion To thank Quote Answer

5/6/2013 7:01 AM	Rate (0)
Ste39 Platinum Member Joined: 1/21/2013 Last visit: 11/20/2024 Posts: 4620 Rating: (710)	Hi jolter ggg, Have a look: How do I set up my MM4 with Starter or DriveMonitor? and Siemens Industry Online Support - Automation Service, Automation and Selection -- Operator Panels and Communication - Siemens Industry or look this thread: PC INVERTER CONNECTION KIT - Siemens Industry Online Support
	Last edited by: Ste39 at: 5/6/2013 7:06 AM
Suggestion To thank Quote Answer

5/8/2013 7:20 PM	Rate (0)
ALGUDKAR RAO Posts: 621 Rating: (10)	jolter ggg i am setting parameters of mm440 by using drive monitor . my drive monitor (software in pc ) is connected to the drive mm440 through zero cable. when i am clicking on online button in drive monitor software there is an warnning error occurs . i am adding here another issue : my pc connection kit have two led green and orange both of them are blinking whether ther you are using USB to serial converter..?
ALGUDKAR RAO Posts: 621 Rating: (10)
Suggestion To thank Quote Answer