Hello,

I want to make an ethernet connection between the IOT2050 P2 and LOGO. They both have a fixed IP adress so that should be ok. My laptop is connected to IOT2050 P2 also with a fixed IP adress.

I've tried to make a Node-red flow between IOT2050 and LOGO but the connection is not OK. Does anyone have more information about the communication settings both in node-red and in LOGOsoft 8.3

Thanks

Which LOGO! use you?

A current LOGO! 8.3?

If yes:
Have you allowed in the file properties the S7 access?

Hello apastore,

Thanks for the reply.

Everything is set up as you described and I've tried to ping from one device to another and that works. 

I'm currently working on a V8.0 (6ed 1052-2md00-0ba8)  but I have one V8.3 that I can use.

When I try to configure a Node-red flow I get an offline message.

As a test I want to read an Dig input in the LOGO, pass it through the IOT2050 and send it back to the LOGO and set a Dig output.

My first questions are:

Do I have to program the IOTGateway in LOGOsoft as a Modbus compatible device or an S7-compatible device

And the same in Node-red: do I use the Modbus Nodes or the S7 nodes (S7 in, S7 out)?

Thanks

Hello ixo56,

I currently use V8.1. Is this the setting you mean (see attachement)?

Kind regards