Good morning,
I need help on a Logo
to program a 0-10 Volt analog ramp
following a temperature curve from +5°C to +15°C
with a PT1000 probe (-40/+100°C range)
(at +5°C I must be at 0 Volt and at +15°C I must be at 10 Volt),
I do not understand how to vary the analog output
according to the temperature between these 2 points,
Thanks for your help

Thank you for your quick help,
the aim of the program is to regulate
a 3-way valve according to a water temperature
knowing that above +15°C it must always be at 10 Volt
and below +5°C always at 0 Volt,
between these 2 temperature points
there must be variation of the 0-10 Volt signal
I am a novice in Logo programming,
this is my first program

Oh yes sorry, i am wrong,
your program is correct,
thank you very very much for your help

happy holidays and have a nice day