SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

F-TM StepDrive

6/23/2024 3:38 PM	Rate (0)
David1981 Posts: 161 Rating: (2)	Hello, I would like to control a stepper motor with the et200sp F-TM StepDrive ST 6BK1136-6SB00-0BU0 card, but I can't find anything on the subject. Could it work with a stepper motor like the one in the link? https://www.cloudraylaser.com/collections/cloudray-closed-loop-nema-17/products/cloudray-67mm-0-3n-m-1-5a-2-phase-nema-17-closed-loop-stepper-motor
David1981 Posts: 161 Rating: (2)
Suggestion To thank Quote Answer

6/25/2024 1:55 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 12/22/2025 Posts: 6062 Rating: (828)	Dear David1981, Basically this motor should run with a F-TM Stepdrive ST. The encoder has A and B track only and no Z track. Hence the drive it self runs not on closed loop speed control s(similar to a servo control). It is a heterodyned stepper mode, to avoid loosing of steps. There the adjustment of the run current is important. The achievabl speed depends not only on the nos of pole pairs, it depends on the run current too. Please find the F-TM Stepdrive manual here: https://support.industry.siemens.com/cs/ww/en/view/109823075
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer