SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

MM440 and EM232

1/21/2006 1:14 AM	Rate (0)
Berg Gold Member Joined: 1/17/2006 Last visit: 12/28/2025 Posts: 555 Rating: (29)	Dear Sirs, Please, Ihavea question to you: How can I connect EM232 Analog output to MM440 to work using +/- 10V (the motor directions will be controlled using analog signal +/- 10V). Please, Is the picture attached correct ? If not, what is the correct way ? Best regards, Berg Attachment EM232_MM440.JPG (976 Downloads)

Suggestion To thank Quote Answer

1/23/2006 12:38 PM	Rate (0)
MicromasterMaster Posts: 22 Rating: (0)	To operate from a +10v / -10v you just need to set P756 = 4, Bipolar input. and connect the analogue output from the module to terminals 3 & 4 on the MM440
MicromasterMaster Posts: 22 Rating: (0)	Last edited by: MicromasterMaster at: 1/23/2006 12:39 PM
Suggestion To thank Quote Answer

7/26/2006 1:44 PM	Rate (0)
The Mechanic Posts: 48 Rating: (4)	Don't forget that you will also need some sort of start command. Do you have an additional DI available for this? Or do you have any other ideas? Mechanic
The Mechanic Posts: 48 Rating: (4)
Suggestion To thank Quote Answer

7/27/2006 5:45 AM	Rate (0)
Berg Gold Member Joined: 1/17/2006 Last visit: 12/28/2025 Posts: 555 Rating: (29)	Hi, Ok, I already have a solution. Thank you very much ! Regards, Berg

Suggestion To thank Quote Answer

Share this page:

Share this page on...