Hello,

Could you please write MLFB number of the drive?

Best regards,

Hristo Mihalev

seaf

hi every bady
i havegat a new cur and i didn t know how download parameter

Hello,

It's very strange doesn't work your settings. Let's repeat again:

⇓ P051 = 3 Access stage "Expert mode" to permit access to P070;
⇓ P052 = 2 Function selection "Initialization";
⇓ P070 Specification of the number of the MLFB of the common rectifier (rating plate data on the unit) according to the table;
⇓ P052 = 0 Terminate the function "Initialize";
⇓ P key The operating display appears and once the MLFB has been modified, the
following parameters are reassigned in accordance with the MLFB:
P071 Rated voltage at the input to the rectifier bridge;
P075 Rated DC current;
P076 Only the ones position is modified; Ones position =1: Ones position =1: only power supply operation possible (is set automatically for P070≥101 (power supply unit))
⇓ The operating display "Switch-on inhibit" (008) or "Ready-to-switch-on" (009) appears after
"Initialization" has been completed.

For profibus card:

Ablauf:
⇓ P052 = 4 Function selection Hardware configuration
⇓ P051 = 3 Access stage Expert mode ( to change the following parameters)
⇓ Set the parameters to configure the optional board.

⇓ P090 = Board, slot 2 (To the RIGHT in the electronics box!)
⇓ P091 = Board, slot 3 (In the CENTER in the electronics box!)
Parameter values for P090/P091:
0: No option board
1: CB Communications board;
2: TB Technology board (only P090);
3: SCB Serial Communication Board;

⇓ P052 = 0 Function selection return;
⇓ P key The operating display appears (r000) while parameters and interval variables are being re-assigned;
- The hardware is initialized;

Best regards,

Hristo Mihalev