SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

HOWTO download parameter outof Simovert P drive?

2/1/2010 11:28 AM	Rate (0)
Rosegarden Posts: 63 Rating: (0)	Hello, I'm trying to download parameters outof an Simovert P drive. I can't find any connector to connector it to the laptop (Drivemonitor). Must I made a specific cableto dothis? Thanks, Remo
Rosegarden Posts: 63 Rating: (0)
Suggestion To thank Quote Answer

2/1/2010 11:39 AM	Rate (0)
umencho Diamond Expert Joined: 3/21/2006 Last visit: 3/30/2025 Posts: 10239 Rating: (1183)	Hello, Unfortunately there isn't possible to connect with Simovert P series. You are right there hasn't any standard interface. I suggest you to record all parameters by hand. They are only 50. Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

2/2/2010 8:25 AM	Rate (0)
Rosegarden Posts: 63 Rating: (0)	Hello Hristo, thank you for the fast reply. If there are only about 50 parameters I as well can write them down by hand. If I'm not mistaken there are in the block A0? Although when I get into the parameters menu I can't open the A0 block. Unfortunately the drive can't be switch off because it's connected to an ID fan. Can you refer toa manual where I can look it up? Thanks again for any help. regards Remo
Rosegarden Posts: 63 Rating: (0)
Suggestion To thank Quote Answer

2/2/2010 8:41 AM	Rate (0)
umencho Diamond Expert Joined: 3/21/2006 Last visit: 3/30/2025 Posts: 10239 Rating: (1183)	Rosegarden Hello Hristo, thank you for the fast reply. If there are only about 50 parameters I as well can write them down by hand. If I'm not mistaken there are in the block A0? Although when I get into the parameters menu I can't open the A0 block. Unfortunately the drive can't be switch off because it's connected to an ID fan. Can you refer toa manual where I can look it up? Thanks again for any help. regards Remo Hello Remo, I have only this. http://www.automatyka.siemens.pl/docs/6SE21_Simovert_P_DTR_en.pdf Hope will helps. Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

Share this page:

Share this page on...