SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

More Analog Module problems

9/28/2010 5:40 PM	Rate (0)
Andy Moods Posts: 33 Rating: (0)	Hi Can someone please help me. I have setup the hardware config to match the physical layout and once i load the program into the PLC, the analog module is blinking red and the CPU is flashing error. I have tried intially to disconnect all the wires and it stays the same. as it stands, i have only connected: pin 1 : +24vdc pin 2: 0V pin 3 ; 0V It is still flashing there is nothing else connected. Pleas help Andy
Andy Moods Posts: 33 Rating: (0)
Suggestion To thank Quote Answer

9/29/2010 11:57 AM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 9/3/2025 Posts: 4416 Rating: (1485)	Hi, What is the order number of your analogic module?
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

9/29/2010 2:25 PM	Rate (0)
Andy Moods Posts: 33 Rating: (0)	Hi Thanks. I have just sorted it out. the problem was power was on the wrong level. top instead of bottom. Thanks again
Andy Moods Posts: 33 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users umencho Denilson Pegaia

Share this page:

Share this page on...