SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

q-address in the ethernet wizard using cp243-1and one analogical module before cp-243-1

2/13/2009 5:10 PM	Rate (0)
kkk1 Posts: 5 Rating: (0)	Hello I,ve a problem whith that communication Can someone tell me what q-address i shoulded write in the ethernet wizard if i have cpu226 and one analogical module before cp-243-1 Regards
kkk1 Posts: 5 Rating: (0)	Last edited by: CS Moderator at: 2/16/2009 10:50 PM new subject after splitting
Suggestion To thank Quote Answer

2/16/2009 6:32 PM	Rate (0)
J_Bell Posts: 5822 Rating: (412)	Dear kkk1, may I ask if you read the text in the wizard? If so did you already determine if it is an analogue input or output you have before the CP? Best regards J_Bell
J_Bell Posts: 5822 Rating: (412)
Suggestion To thank Quote Answer

2/16/2009 6:58 PM	Rate (0)
kkk1 Posts: 5 Rating: (0)	Hi I,ve twice analogue input and analogue output before the CP. I need 3 q-address. Regards
kkk1 Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

2/18/2009 12:26 PM	Rate (0)
J_Bell Posts: 5822 Rating: (412)	Dear kkk1, as you only have 16 DA in your PLC I would say that the Address 2 would be sufficient, but you may decide for yourself. Best regards J_Bell
J_Bell Posts: 5822 Rating: (412)
Suggestion To thank Quote Answer

Share this page:

Share this page on...