SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Parcel Over-length detection

10/23/2023 8:45 AM	Rate (0)
Erik Skou Posts: 5 Rating: (0)	I need to detect if a parcel on a conveyer belt is too long using two pec's with the maximum allowed parcel length as distance. Any ideas how to do that? It sounds immediately easy. But we have to be sure that it is the same parcel that blocks both pec's.
Erik Skou Posts: 5 Rating: (0)	Last edited by: Erik Skou at: 10/23/2023 09:17:19
Suggestion To thank Quote Answer

10/23/2023 8:50 AM	Rate (0)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 12/25/2025 Posts: 36377 Rating: (4544)	Sorry, but English is not my native language. So I don't know what you mean with "pec".

Suggestion To thank Quote Answer

10/23/2023 8:56 AM	Rate (0)
Erik Skou Posts: 5 Rating: (0)	pec = photocell
Erik Skou Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

10/23/2023 9:56 AM	Rate (0)
Denilson Pegaia Diamond Expert Joined: 9/23/2005 Last visit: 12/24/2025 Posts: 4434 Rating: (1487)	Hi, there is two sensors, BeginSensor and EndSensor. If "something" act in both sensors at same time, it is a faul state. However it could be possible that "different things" act in the sensor individually logic suggestion Each BeginSensor positive edge increase a counter1 Each EndSensor positive edge increase a counter2 if BeginSensor and EndSensor are true and counter 1 = counter 2, then there is a fault state.
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

10/23/2023 12:03 PM	Rate (0)
Erik Skou Posts: 5 Rating: (0)	Thank you for the advice.
Erik Skou Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

10/23/2023 4:42 PM	Rate (0)
Gerard_mx Advanced Member Joined: 6/14/2014 Last visit: 9/25/2024 Posts: 10 Rating: (0)	Hello. I suggest you use a normally open contact for the begin sensor and a positive edge detection contact for the end sensor. If Begin sensor = TRUE and End sensor positive edge = TRUE, SET an alarm bit.

Suggestion To thank Quote Answer

Share this page:

Share this page on...