Hi everyone, 

I am looking at the manual of this PM-E (please look here https://support.industry.siemens.com/cs/document/25547978/simatic-et-200s-distributed-i-o-power-module-pm-e-dc24v-(6es7138-4ca01-0aa0)?dti=0&lc=en-GB).

In Chapter 4 it says: 

"You can control and monitor option handling, and evaluate the status byte of the power module using the control (PIO) and feedback interface (PII). The address range of the control (PIO) and feedback interface (PII) depends on how the corresponding entry in the configuration software is configured, or which entry has been selected. This table shows the PII feedback interface and the PIO control interface for different entries."

The problem is that I can not set option handling neither in Step7 V5.4.5.4 nor Step V5.5 SP4: I am particularly interested in the version V5.4 but I can't even do that in V5.5 that seems to have new features (please refer to the previous topic https://support.industry.siemens.com/tf/ww/en/posts/step7-dynamic-configuration/153969?page=1&pageSize=10)

Thanks

Hello,

in Step7 V5.5.4 i can activate the Optionhandling for this Powermodule with a Interface module ET200S IM151-3 PN like it is described in the manual for the example "29430270_OH_ET200S_PN_DOKU_V10_en.pdf" from the link :
https://support.industry.siemens.com/cs/gb/en/view/29430270

Regards

Chgristoph