SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Something wrong with Control panel.

8/7/2019 7:33 AM	Rate (0)
kryuchkovAA Posts: 4 Rating: (0)	Hello. I'm trying to commissioning one of my drive units, but button "enables" in Control Panel is not active. What wrong i do ? or something wrong with STARTER ? STARTER v.5.3. System SINAMICS S120. Attachment #1.png (261 Downloads)
kryuchkovAA Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

8/7/2019 8:16 AM	Rate (0)
RB91 Gold Member Joined: 4/28/2015 Last visit: 1/14/2026 Posts: 1278 Rating: (302)	Please click on the button above "LM" to enable first the line module before enabling the drive.
	Best regards, Robert
Suggestion To thank Quote Answer

8/7/2019 8:39 AM	Rate (0)
kryuchkovAA Posts: 4 Rating: (0)	Thanks for answer. I'm pushing "LM". And here... Attachment #3.png (271 Downloads)
kryuchkovAA Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

8/7/2019 8:47 AM	Rate (0)
RB91 Gold Member Joined: 4/28/2015 Last visit: 1/14/2026 Posts: 1278 Rating: (302)	So please check the state of the infeed first. If you commissioned it new I guess it could still be in quick commissioning mode, so you need to change p10 to ready.
	Best regards, Robert
Suggestion To thank Quote Answer

8/7/2019 12:18 PM	Rate (0)
kryuchkovAA Posts: 4 Rating: (0)	Thanks for answers. I found reason. I was should change p0864 from some control bit to 1.
kryuchkovAA Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

8/7/2019 1:01 PM	Rate (0)
RB91 Gold Member Joined: 4/28/2015 Last visit: 1/14/2026 Posts: 1278 Rating: (302)	Yeah, this depends on your used infeed. Infeeds with DRIVE-CLiQ should give their feedback signal usually to the drives with r863.0 (at p864 of the drives). Setting p864 to fixed "1" is not the optimum solution then, because the drive always "thinks" that the infeed is in operation but maybe it isn't and then the drive would try to start even when the infeed is not switched on.
	Best regards, Robert
Suggestion To thank Quote Answer

Share this page:

Share this page on...