Hi , i want to install a deepseaplc board to automate the generator please guide me in the priest wire the deapsee model is 45/20

------------------------------------------------------------------------------------------
Split from cable and wire production machine.

 Hello,

Ghesmat

Hi , i want to install a deepseaplc board to automate the generator please guide me in the priest wire the deapsee model is 45/20

 you probably didn't noticed that you're on Siemens support Forum. On other side, no one here can you teach with also programming, this work you need do by yourself. We can give you help with Siemens products here.

 Hello,

Ghesmat

What s the relation? Deep sea is kind of plc And i ask about wiring 

 again pls, you're inside S7 Conference so I therefore I gave you info but you probably don't understand what is S7, or? Is your connection depended to S7 system/PLC/device? I understand this as negative.

Hello,

ok, so what wiring you want to do?

Hello Geshmat;

Say you drive a Toyota, and you need to do a checkup;  what service will you get if you bring your car to a Mercedes dealer? It's not that Mercedes techs are not competent, they just do not know about Toyotas, have no documentation, and have no spare parts.

I strongly suggest you use the contact information for Deep Sea Electronics to reach out to their technical support and ask for the manuals and documentation.

https://www.deepseaelectronics.com/

Hope this helps,

Daniel Chartier

Hello how are you

We have machine plastic has GE fanuc plc , series 90_30 

I want to know about programming and wiring and set up machine please help me thanks

Hello Ghesmat;

You ask the same type of question, so we have to give you the same type of answer. Specifically, since we are not GE Fanuc programmers, we kind of work mostly with Siemens.. so read on:

Collection of GE FANUC 90 30 manuals from Google.

Hope this helps,

Daniel Chartier