PLEASE SIEMENS EXPERT HELP ME and I think another people also need in trouble shooting.

however if some one have the drawing. can you please share here , help me for trouble shooting.

I find where is my old post, but I checked all of them did not find that drawing, only found cable for X151 order# 

thanks in advance

nulizhang

I am looking for SIMODRIVE Equipment bus X151 drawing of pin out (some document call device bus-ribbon cable )--that is from Power supply module to every drive control card (611A,611D,611U) and also to 840D NCU.

PLEASE SIEMENS EXPERT HELP ME and I think another people also need in trouble shooting.

however if some one have the drawing. can you please share here , help me for trouble shooting.

I find where is my old post, but I checked all of them did not find that drawing, only found cable for X151 order# 

thanks in advance

Hi,

https://support.industry.siemens.com/tf/ww/en/posts/31068/

maybe you are looking for this???

Regards

I had a problem with Spindal Drive Heat Sink Over Temperature.

No specific information was available in this regard, therefor I have to dig out the info by Revers Engineering of the both units. It was a difficult work, but I had no choice. Therefore I did it. 

Both Heat Sinks ( Infeed Unit & Spindal Drive) have 150 Degree Bimetal Temperature Switch. These Switches pass the +15V Supply to the Infeed unit Alarm Monitoring Module X192 on the Supply Board.

Some details of Simodrive Equipment Bus have also be needed to dig out to solve the above fault.

I am still working on it.

I attach the my effort in the form of PDF.

I hope this will be helpfull for any body. Thanks

Engineer Nasir Ahmed  [snip]