SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Analog Card SF

8/28/2024 5:55 AM	Rate (0)
onboardx Member Joined: 6/24/2022 Last visit: 10/23/2024 Posts: 18 Rating: (1)	Hello, I have 2 problems. 1-I am getting the following error on the 8-channel Analog Input card in the S7-318 system. The jumber setting for CH4-5 was wrong at first and after changing it, I am getting the same error again. How can I solve this?(Please refer to Picture). 2-When I am online in the program, the analog PIW addresses do not react when the external 0-10 V or 4-20 mA values change, it always shows 0. However, I see the manipulated value at the FB output. Attachment 789.PNG (263 Downloads)

Suggestion To thank Quote Answer

8/28/2024 6:39 AM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 11/6/2024 Posts: 8768 Rating: (1170)	Hello, 1. Which analog card are you using? What is connected to Channel 4 and 5? And how are they parameterized? 2. How do you check the PIW address? Try to use a Move instruction, to move it to a MW or DB.DW. What does it show? Best regards, Wizard

Suggestion To thank Quote Answer

8/28/2024 10:53 AM	Rate (0)
onboardx Member Joined: 6/24/2022 Last visit: 10/23/2024 Posts: 18 Rating: (1)	Hi, I solved the system fault error.the channel configuration was set according to voltage but it should be current.I moved INPUT to another channel and there it shows -32768

Suggestion To thank Quote Answer

8/28/2024 1:39 PM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 11/6/2024 Posts: 8768 Rating: (1170)	Hello, When the inputword shows -32768, there is probably underflow. How is the sensor wired? Best regards, Wizard

Suggestion To thank Quote Answer

Share this page:

Share this page on...