ruisoares

Hello,

I have a RF240R RFID Reader with IO-Link.

This device is connected to a external vendor profinet unit from Festo. This unit is already connect and provide the port and the 32 bytes of in/out.

And using the template below i was already able to check presence of a rfid tag:https://support.industry.siemens.com/cs/pt/en/view/73565887

However when i trigger read or write functions i never get feedback from the functions. (Inside the FB is stuck inside Switch antenna on).

Question: Should i really use this template or this is just to use on siemens io-link ports? Do i need to configure something with the PCT Tool? What should i put on the port address input of the FB? Is there another way to do this?

Thanks in advance.

Attachment

Device.PNG(186 Downloads)

Bonjour,

j'ai le même problème que vous avec un lecteur RF210R connecté sur un module Festo IO-Link CPX-AP.

Avez-vous trouvé une solution ?

Merci d'avance.

------------------------------------------------------------------------------------------
Split from RF240R IO-link from External Vendor.

Bon jour ;)

were you able to switch the operating mode (via PCT) to

User data - access to user data of tags?

Bonjour,

Oui j'ai changé le Mode en Scan User

Hello AutoGen_945108,

Please try to discuss your question in English language. This is an international community, and we try to focus on one language. Posting in English will help you to get more response to your question.

These are the translations of your posts:

AutoGen_945108

Hello,

I have the same problem as you with a RF210R reader connected to a Festo IO-Link CPX-AP module.

Have you found a solution?

Thanks in advance.

AutoGen_945108

Hello,

Yes I changed the Mode to Scan User

Regards
Jen_Moderator