Skip to Content

support.automation.siemens.com | Technical Forum | Monday, September 15, 2025 7:06:28 PM

Print

Start of transfer tool

Created by: Fred Floggle at: 6/7/2006 5:35 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

6/7/2006 5:35 PM	Rate (0)
Fred Floggle Posts: 17 Rating: (1)	Thanks for your help - another question , winncc flex based , have you ever had problems getting Flex to start the transfer tool from inside flex ? If I try , I get a VB runntime error - but if I create a desktop shortcut , and run this first , the flex will call the transfer tool - sounds like an issue with the path to me . thanks !
Fred Floggle Posts: 17 Rating: (1)	Last edited by: CS Moderator at: 6/7/2006 7:35 PM new title
Suggestion To thank

6/7/2006 6:31 PM	Rate (0)
Nemo Posts: 3149 Rating: (172)	Hi, please open a new thread for a new question [:D] => the moderator will move this thread.... Which WinCC flexible version and panel do you use? Which operating system has been installed on your PC? Is there any other software installed on your PC? nemo
Nemo Posts: 3149 Rating: (172)
Suggestion To thank

6/7/2006 8:54 PM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 8/22/2025 Posts: 4114 Rating: (195)	Close: cause thread is posted twice. The other thread with answers you can find here: Flex Transfer problem
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank