SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

D410 (-1) DP Problem

11/20/2021 12:02 PM	Rate (0)
Davinator Gold Member Joined: 1/4/2013 Last visit: 1/13/2026 Posts: 1195 Rating: (106)	Dear all, I have a D410-DP FW4.3 which, after some seconds on the power on, starts showing ONLY the RUN/STOP led blinking in RED color. The blink is around 1s. THe unit is not reachable by Profibus , I tried to reformat the CF, redo the bootloader and even with the firmware only , the behaviour remains always the same. What could I do ? Danke
	Searching for Siemens used/new equipments ? Take a look here : https://www.ravettiautomation.com
Suggestion To thank Quote Answer

12/7/2021 2:01 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 1/14/2026 Posts: 6066 Rating: (828)	Hello, maybe a contact in the CF-card slot is damaged.
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

12/12/2021 10:17 AM	Rate (0)
Davinator Gold Member Joined: 1/4/2013 Last visit: 1/13/2026 Posts: 1195 Rating: (106)	Really a damaged contact dan do that ? Because for some minutes the Simotion seems OK, then, suddenly, shows those leds... What does these leds means ? In the manual I cannot find nothing about them
	Searching for Siemens used/new equipments ? Take a look here : https://www.ravettiautomation.com
Suggestion To thank Quote Answer

12/13/2021 3:35 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 1/14/2026 Posts: 6066 Rating: (828)	Hello, because leds there are only the description in the manual. https://support.industry.siemens.com/cs/de/en/view/109801514 When D410 is OK for a few minutes, I would go online and read diagnostic buffer. But I guess D410 will not start correctly .
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

Share this page:

Share this page on...