Hello

i have a issue...

two TP1500 HMI Panels with SIMATIC S7-300 (WinCC Flexible RT and STEP 7 V5.5)

This are connected via TCP IP config.

Both panels are communication to the PLC.

But which commando can i use to make the other panel to switch picture if the other is operated also?

any guide or tips would be nice?

I think you could make a solution using a Area Pointer " Screen Number" and an event in the HMI Change Screen by Number.

If HMI_1 change screen, HMI_2 detects that a change has happend throug a tag, and the event Change Screen by Number runs

Hello Brobakken,

Perhaps this link might help:

How do you configure a screen change via the controller in WinCC (TIA Portal)?

Best regards,

Wizard

Thank you will look for it :)

[snip]

New question published by Brobakken is split to a separate thread with the subject TP700 Comfort - need to automatic change the screens.

Best regards
Jen_Moderator