Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

writing data to simocode pro V

Created by: Tita_NL at: 3/5/2009 9:00 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

3/5/2009 9:00 PM	Rate (0)
Tita_NL Posts: 4 Rating: (0)	Hi all, I have acustomer that wants to write data into dr 130 of the simocode... ( max I, etc, because differnt motors are connected to it) I read the data perfect with : [code] CALL "RD_REC" REQ :=M1.4 IOID :=B#16#54 LADDR :=W#16#1FFA RECNUM :=B#16#82 RET_VAL:=MW22 BUSY :=M1.5 RECORD :=P#DB130.DBX0.0 BYTE 91 AN M 22.7 JC net7 //Jump if RLO=1 to jump label net7. L MW 22 T MW 28 net7: AN M 1.5 R M 1.4 [/code] then i want to write the data back with : [code] CALL "WR_REC" REQ :=M1.6 IOID :=B#16#55 LADDR :=W#16#1FFA RECNUM :=B#16#82 RECORD :=P#DB130.DBX0.0 BYTE 91 RET_VAL:=MW24 BUSY :=M1.7 AN M 24.7 JC net8 //Jump if RLO=1 to jump label net8 L MW 24 T MW 26 net8: AN M 1.7 R M 1.6 [/code] Reading data will give me that db130 is populated correct. When i want to write the same data i get 8082 The configured slot is not occupied. anyone any idea how to solve this ? tnx
Tita_NL Posts: 4 Rating: (0)
Suggestion To thank

3/6/2009 9:54 AM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 11/14/2024 Posts: 4113 Rating: (195)	closed cause question posted twice. The second thread with the subject Writing data to simocode proV is published within the conference Industrial Controls Best regards CS Moderator
	Last edited by: O_Moderator at: 3/17/2010 10:50 AM conference-link edited My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on