RF260R with s7-300 error 0xE6FE03

Hello everyone,
Im currently comissioning a RF260R connected to a rf185c via rs422. Im using the example program used in this documentation : [snip]
When sending an Init to the reader im getting the error 0xE6FE03. When looking at the error description it says that it could be a bad parameter assignment, but i have used the sample program or that the “Length of the input/output areas too small for the cyclic I/O word” but i dont really understand what that means.
Any help would be appreciated. 

Hi,
I dind't take a deep look. I noticed the title of the document contains RF300, you're using a RF200. Maybe the setting for the used tag is incorrect (RF300 instead of RF200). It's in the last byte.

Yes you're right, what do you mean by the last byte ? 

Here's the manual for the IdentProfile block:

https://support.industry.siemens.com/cs/ww/en/view/109978379

Page 79 shows the structure of the data sent to the reader (command WRITE-CONFIG). Description for the last byte (16) is on page 85. It needs to be 1 in the case of RF200.

 

Thanks, I wil be trying that today