Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

configuration SM336-HART

Created by: turbomedia at: 7/4/2012 2:09 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

7/4/2012 2:09 PM	Rate (0)
turbomedia Posts: 10 Rating: (0)	DEAR ALL i have big problem for configuration SM336 analogue failsafe card with HART protocol support , i considered F system config V5.5+SP8 for hardware but for channel drive in software i didnt find any matching software available , i think , it the F-SYSTEM software should change from F-V5.2+SP4 with library failsafe V1.2 to F-V6.0 op upper than it with V1.3 library , if you have other solution i'm hearing from you. thank you
turbomedia Posts: 10 Rating: (0)
Suggestion To thank Quote Answer

8/1/2012 8:15 AM	Rate (0)
Cicero Gold Member Joined: 10/10/2005 Last visit: 1/29/2025 Posts: 1940 Rating: (138)	Hello, use the following link for further informations of downloads. I hope this could useful for your. http://support.automation.siemens.com/WW/view/de/15208817 With best regards Cicero

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on