Network I/O

Further to my 2 previous posts, this is what we have so far.

5 LOGO 0BA8 Pure getting readings from flow meters and displaying on a LOGO TDE. All of this works brilliantly. The problem I have is getting the counts to display on a seperate totalising 0BA8 and TDE via network I/O. Everything works fine in simulation but not on the actual installation. I can't upload any progs from work but I will do this evening from home.

Any pointers will be very much appreciated.

Thanks for the reply Helmut.

I have checked, re-checked and checked again.

Everything works perfect in Sim and as you say drag and drop makes it very easy. I have included the program for your entertainment.

I1 sets the low level and turns on Q1

I3 is the pulse counter

After a 3 second delay Q2 turns on and the pulses are counted into a second register.

Q3 should output to NI1 on the second LOGO

Q4 should output to NI6 on the second LOGO