3/3/2006 6:03 PM | |
Joined: 9/27/2005 Last visit: 11/27/2007 Posts: 1398 Rating:
|
Have you seen this http://support.automation.siemens.com/WW/view/en/8776459 There is a section that describes how to communicate with WinCC. I have not used Simadyn myself so I cannot offer any further advice. Regards, Salma |
3/3/2006 6:18 PM | |
Joined: 3/3/2006 Last visit: 8/6/2024 Posts: 28 Rating:
|
Thank for the quick answer but I'm using Struc G 4.2.5. |
3/3/2006 6:26 PM | |
Joined: 9/27/2005 Last visit: 11/27/2007 Posts: 1398 Rating:
|
Oh well. I hope someone else can help out. |
3/3/2006 7:33 PM | ||||||||||||||||||||||||||||||||||||||||
Posts: 3149 Rating:
|
Hi , there is a Channel available for TDC / WinCC. This addon has been developed by the WinCC Center of Competence in Erlangen: http://www.industry.siemens.com/IT4Industry/EN/SOLUTION_SERVICES/SIMATIC_ADDONS/KANAL.HTM
Enjoy your weekend :-) nemo |
|||||||||||||||||||||||||||||||||||||||
Follow us on